programming yoke buttons in Xplane11

[mushtaq]

Hello Every one
i just started to use the brunner CLS-E yoke and i am pleased with it but i can not assign any yoke buttons within the Xplane11 joystick calibration i can see the virtual joystick in the controls column but when i try to calibrate it nothing happens i can assign the buttons in profile manager with no problems but i would like to assign some buttons on yoke for plug ins can some one guide me in right directions please i will be gratfull
TIA
Mushtaq

[rashadwell]

if you want to use xplane 11 to program the buttons, then you must un-assign the buttons using the brunner buttons tab. Once they are un-assigned xplane will “see” the buttons and you will be able to assign them. I use a combo of brunner software and xplane software. So for example, button number 1 is assigned using xplane as contact atc. In the brunner software I have button 1 un assigned. Button 2 is trim down in brunner software. Xplane does not recognize button 2. However, the command of trim down does work, because brunner is telling xplane about button 2.

Hope this helps.

[Author]

Posts