Tagged: yoke buttons
- This topic has 0 replies, 1 voice, and was last updated 3 years, 11 months ago by
johnrutoski.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
17/09/2020 at 04:54 #2030
johnrutoski
ParticipantI have a dual yoke CLS-EMKII yoke and rudder system and have upgraded the firmware to V473 and I am using the CLS software version 4.27.1. after the upgrade the when installing the new CLS software it only detected one yoke and rudder combo but I have two yokes and two rudders connected to a E2can ethernet connection. The buttons worked with the old firmware and older CLS software. I know I probably should not have upgraded them but I went ahead and did it. Now the number of buttons are less and I have a hat switch on each yoke and they do not show up either.
Any help would be greatly appreciated.
John
-
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.