FORUM Forums Products CLSE-Yoke Firmware update failed (CLSE NG)

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #2598
    aurel42
    Participant

    When updating the firmware of my CLSE NG yoke, I get the message “Update failed: couldn’t load defaults” on node 2.
    Node 1 reports “Successfully loaded defaults”.
    The message in the center of the window (above the green arrow) says “Update Successful”.

    I’ve tried repeating the update, the results were the same.

    Do I need to worry, or can I ignore the error message?

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau


+41 (0)44 953 10 10
info@brunner-innovation.swiss

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice