Thumb controller on yoke only a digital output? – BRUNNER Innovation

This topic has 0 replies, 1 voice, and was last updated 1 year, 2 months ago by sleepy81.

Viewing 1 post (of 1 total)

Author

Posts
03/09/2023 at 16:23 #3222

sleepy81
Participant

I have calibrated the thumb joystick on the CLS NG yoke in CLS2Sim on the Analogue Axis tab, and it seems to work fine there. However it is only detected as a digital D-pad/FOV buttons in MSFS. I want to have analog axis control for moving the camera etc. but can’t seem to figure out how to configure CLS2Sim to actually report the mini-stick as an analog axis, not buttons.
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER Forum

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns.

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk

Do you have questions about a product you have already purchased or are you facing technical issues?

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10
info@brunner-innovation.swiss

BRUNNER Forum​

BRUNNER Helpdesk​

BRUNNER Simulation​

BRUNNER Simulation

BRUNNER Forum

BRUNNER Helpdesk

BRUNNER Simulation