Yoke needs constant right roll force

[farfuturefox]

Hi, I’m having problems after several years of good usage of my CLS-E Mk II. I need to apply a constant right roll force, of up to 70nm (as shown in in the yoke’s display) depending on the aircraft, to keep the yoke level. Sometimes there’s a -4 degree tilt to the left when I take my hands off, sometimes not. It happens in multiple aircraft. Even when there’s no tilt, I need to use a right roll force. I’ve tested in multiple single aircraft (ruling out asymmetric engine power). I’m using any profile, including the Default.

(The support form doesn’t submit the form, so I’m trying here).

Thanks for the help.

[Diego Bürgin]

Hi farfuturefox

If you cannot open a ticket, please write to support@brunner-innovation.swiss

As for your problem:
In CLS2Sim:
In the connection settings, in the Simulator group box, disable “Auto connect”.
Make sure you’re only connected to the hardware side, not the sim.
Create a new profile.
In Hydraulics enable “static force scale factor and set a force scale of 400
Press Apply button.

Does the yoke roll center, or does it pull left?
Write us your observations to the support email.
Regards
Diego

[Author]

Posts