FORUM › Forums › Software › CLS2SIM Software › Remote control CLS2SIM software?
- This topic has 3 replies, 2 voices, and was last updated 6 years, 6 months ago by
sbrunner.
-
AuthorPosts
-
25/02/2018 at 11:54 #742
lubidux
ParticipantHi, is there a way to remote control CLS2SIM software?
I would like to “connect/disconnect” and “init” my yoke remotely after X-Plane 11 is started. My plan is to use hardware buttons attached to an arduino board and write some code to remote control CLS2SIM software functions.
Thanks in advance
Res26/02/2018 at 20:05 #746sbrunner
KeymasterHi
You can use Remote Control Interface (TCP/IP or UDP)
see here…
https://cls2sim.brunner-innovation.swiss/RCInterface.htm
https://cls2sim.brunner-innovation.swiss/protocolv2.htmRegards
Stefan Brunner
28/02/2018 at 10:53 #747lubidux
ParticipantThank you Stefan,
I was study the remote control interface a bit, its exactly what i’m looking for! – But which function is used to connect the yoke? – Is there a way to “auto-connect” the yoke somehow after starting CLS2SIM software? Is the connection done with the “State command”->”Initialize”?
Maybe a example script or software in C, Python or whatever would be helpful…
Thanks for any help
Res28/02/2018 at 11:06 #748sbrunner
KeymasterHi
Auto Connect is done in Connection Settings
see https://cls2sim.brunner-innovation.swiss/SettingsForm.htm
The yoke must be connected before talking to Remote InterfaceWithout a yoke communication is not possible
Regards
Stefan Brunner
-
AuthorPosts
- You must be logged in to reply to this topic.