FORUM Forums Products CLSE-Yoke Realistic trimming in P3DV4 and XP11 Reply To: Realistic trimming in P3DV4 and XP11

#872
vvince
Participant

Thanks for your reply Medtner, a lot of usefull information!
I am not planning to extensively use autopilot, as you says, it would be a pity to put the hands off the yoke! Only when setting up the GPS or such.
Your experience with trimming in P3D is reassuring I have to say. Just to make sure, since it differs from the one of Ady, that we mean the same thing with realistic trimming : say you are level by holding the yoke in a certain position, rotating the trim wheel accordingly decreases the force needed to hold the position of the yoke, until no force is needed anymore. At this point the yoke remains in the same position whithout holding (the plane is trimmed).
Is it what you can achieve with the trim wheel in “hardware trim” mode?

Thanks,

vvince

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau


+41 (0)44 953 10 10
info@brunner-innovation.swiss

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice