FORUM › Forums › Software › CLS2SIM Software › Yoke won't move when autopilot is engaged in the Zibo mod in XP11 › Reply To: Yoke won't move when autopilot is engaged in the Zibo mod in XP11
dusfor63I will refrain from updating to 11.30, although I was told it has some interesting improvments and stay with the “vintage” :-))))) version.
The worst thing after 3.31J is that if you activate the autopilot it constantly oscilates up and down as if the yoke is either running behind or is disturbing the autopilot. depending on the setting in the controls config in the mod, if you activate the AP, it instantly jumps to CWS that makes obvious that the yoke is interfering the logic instead of following it. Quiet sure that if that is fixed the other problem will go away as well, because I think the yoke / software is not synchronizing the trim together and has different opinions 🙂 what the right position of the yoke should be. On disconnect AP that forces us to pull / push a lot depending on the aircrafts attitude.
Sorry, a bit lengthy text, but perhaps helps Diego.
Güner
