Reply To: Effects-Yoke physics

[kevin]

Performed additional “ground test” …

Settings
CLS2Sim v4.20.1 [Effects] tab settings
– Yoke is pulled forward by Elevator weight section
– Speed at Yoke starts to be affected = 35
– Speed at which yoke gets pushed to middle = 50

Test results (IAS reading from CLS2Sim v4.20.1)
– No Yoke movement at 35 or 50 IAS (full forward)
– Yoke begins to pull back at 90 IAS and continues to pull back as aircraft accelerates
– Reducing speed from 110 IAS, Yoke moves forward as aircraft slows, at around 50 IAS Yoke movement stays around middle
– Speed below IAS 50, yoke move to full forward position

It would appeared that the initial push to middle at IAS 50 function doens’t work ?

Any thoughts on how to correct this issue or if I’m missing something in the setting?

Thanks.