FORUM › Forums › Software › CLS2SIM Software › cls E mk II:rudder and yoke via usb but can only see one or the other not both › Reply To: cls E mk II:rudder and yoke via usb but can only see one or the other not both
richardtsllcI have this same issue!! When I purchased the CLS-E Yoke and Rudder package NOTHING was stated anywhere up front about the requirement of CAN; i.e., does that mean I need to buy a CAN box or something? WTF?!? If so, where is that CAN box described and listed on the Brunner site?
Or, does the reply to the previous post means is it as simple as connecting an RJ45 cable from the yoke to the rudder, then USB into the PC? Which RJ45 connector on which unit? 0 to 0? 1 to 1? 1 to 0? There’s NOTHING in any of the support documents specifically describing that necessity and process. If I missed it, I’m happy to be corrected after it’s clearly pointed out.
Also, I’ve created at least two trouble tickets about this issue, yet no response from Brunner. High quality hardware, low quality of timely support response?
