- BRUNNER Innovation

21/11/2017 at 09:51 #664

Participant

The problem is resolved and working fine also with 4.7.0 and the 350 firmware so all is good.

When I talked to Diego I think we agreed my yoke ended up in a state where it thought the auto pilot was still engaged even after P3D wasn’t running. Reason for this was probably P3D crashed mid-flight with the AP enabled.

I suggested to Diego maybe a good check to implement to avoid these kind of issues could be to always check when CLS2Sim is started if the simulator is running. If not, the AP should never be engaged.

BRUNNER Forum

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns.

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk

Do you have questions about a product you have already purchased or are you facing technical issues?

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10
info@brunner-innovation.swiss

BRUNNER Forum​

BRUNNER Helpdesk​

BRUNNER Simulation​

BRUNNER Simulation

BRUNNER Forum

BRUNNER Helpdesk

BRUNNER Simulation