FORUM Forums Products CLSE-Yoke Max force required for both axes for no obvious reason Reply To: Max force required for both axes for no obvious reason

#751
webmaximus
Participant

How did the simulator shut down last time before this happens?

I had a similar issue caused by my simulator crashing with the autopilot connected. Next time I started the simulator my yoke reacted like you describe and like the AP was still connected although it was not caused by the previous unclean exit.

The simple solution was to overpower the yoke just like you’re able to during flight to disconnect the AP. After that the yoke was behaving normally again.

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau


+41 (0)44 953 10 10
info@brunner-innovation.swiss

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice