cls E mk II:rudder and yoke via usb but can only see one or the other not both

[cawils]

Added a clsE MKII rudder to cls e mkII yoke which was working when used alone. At first only yoke recognized in cls2sim. After attempt to restart cls2sim, now only rudder recognized. Can only one device be connected to cls2sim?

thanks

[sbrunner]

Hi you need to connect the Rudder and Yoke over CAN with an RJ45 cable and then connect with one of them over USB to CLS2Sim
Regards

[richardtsllc]

I have this same issue!! When I purchased the CLS-E Yoke and Rudder package NOTHING was stated anywhere up front about the requirement of CAN; i.e., does that mean I need to buy a CAN box or something? WTF?!? If so, where is that CAN box described and listed on the Brunner site?

Or, does the reply to the previous post means is it as simple as connecting an RJ45 cable from the yoke to the rudder, then USB into the PC? Which RJ45 connector on which unit? 0 to 0? 1 to 1? 1 to 0? There’s NOTHING in any of the support documents specifically describing that necessity and process. If I missed it, I’m happy to be corrected after it’s clearly pointed out.

Also, I’ve created at least two trouble tickets about this issue, yet no response from Brunner. High quality hardware, low quality of timely support response?

[jovabra]

Hi,
My set-up =
Yoke to rudder with a standard ethernet cable and the rudder with a USB cable to the computer.
Select in the CLS software in the green box USB HID the CLSE rudder option.
No additional software/hardware is necessary
Regards
Jo va Bra

Attachments:

You must be logged in to view attached files.

[richardtsllc]

Simple as that, thank you very much for responding.
I did finally get a response from Stefan, apparently that answer is on Page 34 of the Quick Start Guide. But, where’s the link to it?

[Author]

Posts