FORUM › Forums › Software › CLS2SIM Software › Homing error timeout @ aileron (1)
- This topic has 5 replies, 2 voices, and was last updated 6 years, 4 months ago by
franciscoblas.
-
AuthorPosts
-
23/04/2018 at 11:46 #802
franciscoblas
ParticipantHi Brunner,
I am getting “Homing error timeout @ aileron (1)”
Elevator is okay “green”
Aileron connected but not init “yellowThis just started tonight. I have disconnected power, INIt but still get error when connected via software. In the sim I see right aileron up.
Thank you for any help.
Francisco
23/04/2018 at 12:00 #803franciscoblas
ParticipantI forgot to add that after powering yoke, when I press “init” on yoke, the yoke slams abruptly to left, then right.
Francisco
23/04/2018 at 12:42 #804franciscoblas
ParticipantHi again, I believe I have a hardware problem
Francisco
23/04/2018 at 15:00 #805sbrunner
KeymasterHi Francisco
Can you open a ticket in the helpdesk
I will send you a software update link to tryRegards
Stefan Brunner
24/04/2018 at 06:01 #806franciscoblas
ParticipantHi Stefan,
Is it possible to send me the latest firmware so i can reflash the yoke, maybe that will help. Being that we are 12 hours difference it is almost impossible to use teamview. When you asked for teamview ID, I was at work at the time, not in front of my PC. Have you seen the video of the problem? I’ve already updated to latest CLS2Sim version, still same issue. I have put less than 40 hours of use since receiving this yoke and such an issue like this arises. i would like to get back to flying again.
Thank you for any help.
Francisco
24/04/2018 at 10:28 #807franciscoblas
ParticipantHi Stefan,
Thank you for your help and patience with me via teamviewer.
Francisco
-
AuthorPosts
- You must be logged in to reply to this topic.