FORUM › Forums › Software › CLS2SIM Software › Flight Simulation Software › Microsoft Flight Simulator 2020 & Brunner Hardware › MSFS SWS PC-12 Roll and rudder axes not working
- This topic has 4 replies, 3 voices, and was last updated 7 months, 1 week ago by Willem Van der Voort.
-
AuthorPosts
-
09/12/2023 at 10:13 #3662blaserParticipant
Hi,
These axes are not seen through simconnect. Is there a way to assign Aileron & rudder Lvars as outputs from the CLS-E Yoke and rudder ?
Regards
Ahmed15/12/2023 at 01:35 #3673airmanmdParticipantIf you SPAD.NEXT you can assign the Lvars that way.
16/05/2024 at 13:41 #3817Willem Van der VoortParticipantSimWorks Studios PC-12 for MSFS 2020
pc-12 and brunner CLS-E MK II yoke does not work.
PC-12 aileron is connected to the rudder, therefore my ellerons do not work, the yoke only responds to pitch
I have CH ruder pedals so Ruder does work for me, and they controls the elleron, ruder to the left then the yoke also turns to the left.17/05/2024 at 02:34 #3818blaserParticipantHere is the fix:
1- Check Force map vJoy Axes to Pitch/Yaw/Coll regardless of selected sim in the settings
2- Bind Roll and rudder axis in Vjoy
3- Enjoy17/05/2024 at 17:48 #3819Willem Van der VoortParticipantThanks for your help, it doesn’t work.
I have sent you 4 images, can you please check if I did something wrong.Connecting the aileron to the SIM also works, but that is not the right way,
I still have the PC-12 from carenado and that is also good without any problems.Greetings W
Attachments:
You must be logged in to view attached files. -
AuthorPosts
- You must be logged in to reply to this topic.