FORUM › Forums › Software › CLS2SIM Software › Prepar3d – How to make work
- This topic has 0 replies, 1 voice, and was last updated 3 years, 11 months ago by
severniae.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
25/09/2020 at 17:17 #2044
severniae
ParticipantHas anyone had any luck making Prepar3d work well with the Brunner CLS-E yoke?
As a test I’ve tried the PMDG DC-6 – I can fly reasonably well using hardware trim, forces feel ok. BUT as I get to the upper or lower ends of the speed range, I either lose down elevator authority or up elevator authority. This seems to be because the P3D trim is staying central and for some reason full elevator isn’t available unless trim is set correspondingly.
So I tried software trim using brunner recommended settings – it just doesn’t work..It also messes up the autopilot.
Does anyone have any reccomendation?
Thanks,
James -
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.