- This topic has 7 replies, 3 voices, and was last updated 6 years, 4 months ago by
thedazman.
Viewing 8 posts - 1 through 8 (of 8 total)
-
AuthorPosts
-
21/12/2017 at 03:44 #681
Lee
ParticipantI have mounted my Yoke under the table. Therefore I must rotate the yoke handle 180 degrees to achieve normal operation.
What is the procedure for reconfiguring the yoke handle 180 degrees in lateral rotation?
Thanks!
Lee
Attachments:
You must be logged in to view attached files.20/01/2018 at 13:31 #710rashadwell
ParticipantI have this same situation.
20/01/2018 at 21:20 #711Lee
ParticipantAluminum angle was my mounting solution.
20/01/2018 at 21:54 #71221/01/2018 at 00:19 #714rashadwell
ParticipantThank you for the fast response. How did you take the cover off?
21/01/2018 at 01:44 #715Lee
ParticipantRemove 2 screws on each side. 8 total
24/04/2018 at 23:51 #808thedazman
ParticipantIs there an official solution to this without invalidating the warranty ?
ie taking the handle off and turning ?
Regards Daren
29/04/2018 at 09:20 #809thedazman
ParticipantSeems there isn’t 🙁
In the end I just mounted it underneath using long screws through the existing holes and left a small gap using tap washers, which reduces temps an additional 5 degrees.
-
AuthorPosts
Viewing 8 posts - 1 through 8 (of 8 total)
- You must be logged in to reply to this topic.