- This topic has 0 replies, 1 voice, and was last updated 1 year, 5 months ago by
sleepy81.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
03/09/2023 at 16:23 #3222
sleepy81
ParticipantI have calibrated the thumb joystick on the CLS NG yoke in CLS2Sim on the Analogue Axis tab, and it seems to work fine there. However it is only detected as a digital D-pad/FOV buttons in MSFS. I want to have analog axis control for moving the camera etc. but can’t seem to figure out how to configure CLS2Sim to actually report the mini-stick as an analog axis, not buttons.
-
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.