FORUM › Forums › Software › CLS2SIM Software › Flight Simulation Software › X-PLANE 9/10/11 › Trim and X-plane 11
- This topic has 0 replies, 1 voice, and was last updated 3 years, 11 months ago by
flexcopmnpd.
-
AuthorPosts
-
06/10/2020 at 01:19 #2079
flexcopmnpd
ParticipantCan someone please explain to me how I am supposed to set up trim in x-plane so that I can get realistic behavior out of the yoke. I followed the directions to alter aircraft in plane maker to allow for realistic trim behavior but it does not seem to make a difference. I have a saitek trim wheel that I am trying to use. The profile manager, version 4.27.10, detects the trim wheel and as I spin it the values change. But the yoke also moves in the pitch axis. Is this correct? When I am in the sim and use the trim wheel to trim the pitch forces the yoke rocks back and forth, like the trim wheel is moving the actual elevator and not the trim tab. Any suggestions or settings I may have over looked?
Thanks in advance for any assistance,
Brian -
AuthorPosts
- You must be logged in to reply to this topic.