Xtreme Prototype's GLJ Model LearJet – Trimming issue. – BRUNNER Innovation

This topic has 0 replies, 1 voice, and was last updated 6 years, 2 months ago by bilk.

Viewing 1 post (of 1 total)

Author

Posts
02/10/2018 at 04:07 #932

bilk
Participant

Hi.
Is anyone flying the above aircraft in P3Dv4 using the CLSE-Yoke?
This is a great simulation of this aircraft, but I am having no success in getting realistic trim operation using either the ‘Software’ method or ‘Hardware’ method. The yoke works OK as in conventional mode, but this is not realistic. I have had no problems with a large range of other GA aircraft.
I would appreciate hearing of other’s experience.
Regards,
Bill
Author

Posts

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.

BRUNNER Forum

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns.

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk

Do you have questions about a product you have already purchased or are you facing technical issues?

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10
info@brunner-innovation.swiss

BRUNNER Forum​

BRUNNER Helpdesk​

BRUNNER Simulation​

BRUNNER Simulation

BRUNNER Forum

BRUNNER Helpdesk

BRUNNER Simulation