FORUM › Forums › Software › CLS2SIM Software › Zibo with CLS-NG and CLS2sim 5.6, yoke not following AP

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 01/11/2023 at 22:09 #3614
    Tero Partanen
    Participant

    Hi,

    Could not find how I should set this up so that the yoke will move when AP is controlling the plane.
    I have pitch and roll enabled in Autopilot tab, and I have unchecked “don’t set pos in AP mode”. Trim to zero is unchecked as well.

    I have Brunner support enabled in Zibo EFB. What is the solution?

    01/11/2023 at 22:26 #3615
    Tero Partanen
    Participant

    One addition, seems roll is working but pitch is not moving with autopilot. Very strange initially neither moved.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10
info@brunner-innovation.swiss
Facebook Instagram Linkedin Youtube

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice