[guido]

Hi Ropp29,

I asked this very question recently (note I use Xplane 11). The answer was

‘Have Trim wheel plugged in, and FIRST start CLS2Sim, only afterwards start the sim.

Don’t map the trim wheel in the simulation. In CLS2Sim profile manager you must see the trim wheel.

Leave as is and instead go to CLS2Sim > Profile Manager > Trim tab.

Enable: YES

Velocity: Have to experiment for each plane. Lower if movement too jerky.

Movement: Leave at 100% ! Important !

User external trim : NO

Trim Compensation: NO

Use Hardware trim: NO’

I hope this helps?

Regards,

Guy

[guido]

Hi Diego,
Thank you for the clarification. Does the trim modification (setting the value to zero) using Xplane Plane Maker apply to ALL aircraft, general aviation (GA) and commercial jets or just GA? Is it also applicable to all studio’s Carenado, Just Flight etc?
Thank you,
Guy

[Author]

Posts