Forum Replies Created
-
Posts
-
Thank you very much – the video(s) are helpful.
I’ve posted in a couple of forums here asking for proper settings for a Diamond DA-42. Using settings for the DA-62 (for MS2020) in the Profile Cloud doesn’t feel anything like my (real) airplane, a 2006 DA-42, N327TS. So far, no response at all, from anyone – very disappointing.
May I trouble you for suggestions, please? Notably, I need help with the force settings – both the strength and curves. I have the CLS-E Yoke with a Virpil WarBRD grip, and, the CLS-E rudder pedals. I’m using P3D V4.5 and the Alabeo DA-42. The Alabeo software has a lot of issues as well, but it’s the most realistic I’ve been able to find at this point. They are also relatively worthless in customer support – every issue I report is met with the response, “we’ll consider fixing that in a future update”, or some similar BS like that.
Thank you in advance for your attention and assistance.
Simple as that, thank you very much for responding.
I did finally get a response from Stefan, apparently that answer is on Page 34 of the Quick Start Guide. But, where’s the link to it?I have this same issue!! When I purchased the CLS-E Yoke and Rudder package NOTHING was stated anywhere up front about the requirement of CAN; i.e., does that mean I need to buy a CAN box or something? WTF?!? If so, where is that CAN box described and listed on the Brunner site?
Or, does the reply to the previous post means is it as simple as connecting an RJ45 cable from the yoke to the rudder, then USB into the PC? Which RJ45 connector on which unit? 0 to 0? 1 to 1? 1 to 0? There’s NOTHING in any of the support documents specifically describing that necessity and process. If I missed it, I’m happy to be corrected after it’s clearly pointed out.
Also, I’ve created at least two trouble tickets about this issue, yet no response from Brunner. High quality hardware, low quality of timely support response?
