FORUM Forums Software CLS2SIM Software Yoke won't move when autopilot is engaged in the Zibo mod in XP11 Reply To: Yoke won't move when autopilot is engaged in the Zibo mod in XP11

#1087
jovabra
Participant

Just installed the ZIBO e update and the new CLS2sim V4.19.1. So far so good. The yoke is following the AP but you must unckeck the “don’t set position in AP mode) in the CLS2sim software-Autopilot Tab). I observe a vibration during the flight controle check. I don’t feel it in the yoke itself but observed it in the VC cockpit and on the system page. (rudder-aileron-elevator)
I found no problem when i disengaged the AP so no out of trim situations.
Great job and great service to whom it concern

– I’m using my own profile (test John v Braam)
– latest version of X-plane 11-30 and exprt option is enabled
– Sensitivity settings X-Plane ????
– Yes

Regards Jo va Bra

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau


+41 (0)44 953 10 10
info@brunner-innovation.swiss

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice