FORUM › Forums › Software › CLS2SIM Software › Profile Request- CLS-E NG FF / P3d / Aerosoft(Digital Aviation) CRJ Pro
- This topic has 4 replies, 2 voices, and was last updated 4 years, 6 months ago by
Anonymous.
-
AuthorPosts
-
09/02/2020 at 07:15 #1659
Anonymous
InactiveHello!
I have tried to configure a profile for Aerosoft(Digital Aviation) CRJ Pro but not successful for weeks.
I only suspect it is something about elev trim system because CRJ series have automatic trim system(no physical spinning elev trim wheel).
When I activate Autopilot, it disengages itself very soon, especially when vertical movement is involved.Could anyone upload a profile for this or any hint or clue?
Hmm… I really want to make both work together.Thank you!
11/02/2020 at 16:53 #1660jovabra
ParticipantHi,
I have no problem with the Aerosoft CRJ pro. Yester on the route of EHAM – EGGL and in very bad weather,a lot of wind (Ciara). On FL 240 wind 260degr/100 kts and I didn’t have any unwanted AP disconnect. The yoke follows the AP without any problem.
Regards
Jo va Bra
My profile is in the Brunner profile cloud17/02/2020 at 03:56 #1668Anonymous
InactiveThank you for sharing your experience.
I’m just checking… I assume you did ‘connect’ the yoke with P3D?
You know, on the CLS2Sim, hardware section-connect/init and simulation section-connect… you did all these right?And… I have NG model fyi.
17/02/2020 at 10:44 #1669jovabra
ParticipantYes i did.
Success25/02/2020 at 23:56 #1685Anonymous
InactiveAfter test and test, I learned things.
But I can’t make the yoke follow the roll control(swing left/right) still.
Anyone? any hint?fyi,
Prepar3d v4.5 hot fix 2,
Fsuipc v5,
CLS E NG yoke,
Aerosoft(Digital Aviation) CRJ Profesional -
AuthorPosts
- You must be logged in to reply to this topic.