FORUM › Forums › Software › CLS2SIM Software › Huawei E303 HiLink as serial modem
- This topic has 0 replies, 1 voice, and was last updated 6 years, 6 months ago by
davefollmers.
-
AuthorPosts
-
14/02/2018 at 10:29 #732
davefollmers
ParticipantHello all,
I’m quite new to OpenWrt and i’m impressed about it!!!
Atm I’m using TP-Link WDR4300 and a Huawei E303WS UMTS Dongle with HiLink technology on ATTITUDE ADJUSTMENT 12.09, r36088
So far everything is running, when the PIN code is deactivated on the SIM over the browser of my PC before using it on the router.
Because the WDR4300 will be positioned far away, i like to protect the SIM with the PIN.
My eth1 is the “virtual” eth interface using the usb Dongle to get the internet connection.
wan2 is connected to the eth1As soon as i active the PIN Protection on the E303 dongle no internetconnection can be initiated, which is logical and good.
Now my question is: where i have to setup the pincpode using cdc_ether???
In /etc/config/network eth1 isn’t shown, only my wan2, but there the option pincode ‘XXXX’ doesn’t change anything.
ThanksI didn’t find the right solution from the internet.
References:
https://forum.openwrt.org/viewtopic.php?id=46725 -
AuthorPosts
- You must be logged in to reply to this topic.