Reply To: Yoke won't move when autopilot is engaged in the Zibo mod in XP11

[jovabra]

Just installed the ZIBO e update and the new CLS2sim V4.19.1. So far so good. The yoke is following the AP but you must unckeck the “don’t set position in AP mode) in the CLS2sim software-Autopilot Tab). I observe a vibration during the flight controle check. I don’t feel it in the yoke itself but observed it in the VC cockpit and on the system page. (rudder-aileron-elevator)
I found no problem when i disengaged the AP so no out of trim situations.
Great job and great service to whom it concern

– I’m using my own profile (test John v Braam)
– latest version of X-plane 11-30 and exprt option is enabled
– Sensitivity settings X-Plane ????
– Yes

Regards Jo va Bra