FORUM Forums Products CLS-E Joystick VPC T50-CM2 Grip Compatibly Reply To: VPC T50-CM2 Grip Compatibly

#1451
tzangetsu
Participant

I run into an issue where the buttons don’t work regardless of what I do. I can change the grip type to the CM2 variant, close CLS2SIM then power cycle the joystick as per instructions in the software. But when I re-open CLS2SIM, it’s always recognized as the VPC T-50 grip and not the CM2 version.

I have firmware 394, so I thought it was just an old firmware issue, until I found this post where Stefan mentioned the bit about a “small hardware change”. Is this something that requires the joystick to be sent back to Brunner to get taken care of?

BRUNNER Forum​

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau


+41 (0)44 953 10 10
info@brunner-innovation.swiss

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice