Reply To: Zibo Broken again?

[gian19]

I have seen some little improvement with version .20.
However, I believe the culprit is the way xplane communicate with the yoke. Before, I could see the air plane yoke and the Brunner hardware would move simultaneously. Now, I notice some delay where Brunner try to catch up the movement of the zibo yoke.
This phase shift between the 2 yoke is causing the problem, in my opinion. You won’t notice this issue on route that don’t have massive left and right banks especially at lower speed. The problem is more visible when massive swings occur.
It could also been caused by the recent update that Zibo implemented to the A/P making it more sensitive to joystick pressure. In fact, if you use the more realistic option, you cannot engage the A/P unless you are fully trimmed and aligned with the FD without any pressure on the yoke. I want to make a test flight using the less realistic option to see if the problem is still there. Though, I haven’t figured out yet where is this option on the EFB.