- BRUNNER Innovation

27/12/2023 at 23:19 #3701

Participant

This may be resolved with a simultaneous connection of USB to the PC and CAN bus to the yoke controller. Mapping of the toe brake axis in the simulator or third-party controller software like vJoy, SPAD etc. is then possible via USB. Feedback control to the rudder pedal is transmitted via the CAN bus from the yoke.

A caveat to this is that the software axis reaches maximum value when the toe brake is depressed by 80% or so. I don’t understand this logic, except that the axis appears to be of some resolution greater than 14 bits but, not as high as 15 bits. Regardless of this axis behaviour, the toe brake function is perfectly acceptable using this configuration.

BRUNNER Forum

In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns.

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk

Do you have questions about a product you have already purchased or are you facing technical issues?

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10
info@brunner-innovation.swiss

BRUNNER Forum​

BRUNNER Helpdesk​

BRUNNER Simulation​

BRUNNER Simulation

BRUNNER Forum

BRUNNER Helpdesk

BRUNNER Simulation