Assign yoke buttons in MSFS2020

[jake]

Hi,

MSFS Controls page does not recognize the Brunner Yoke. Can someone tell me how I can assign certain functions to yoke buttons, for example: Toggle parking brake, toggle pushback.

Thanks!!

[webmaximus]

Make sure you have vJoy installed. As I recall it, it’s automatically installed with CLS2Sim but if not, I think you’ll find it for manual installation in the folder where you installed CLS2Sim.

Next, in CLS2Sim, make sure it reports vJoy as installed under the Buttons tab and make sure all buttons are set to ‘USB Unassigned’

This is all from memory without my computer in front of me but hopefully, it’ll push you in the right direction.

[jake]

Hi, Thanks for the suggestions. v-joy did not show up under buttons so i have found the file, and have been running the virtual driver setup now for more than a half hour. The green bar just keeps going across the page. I cannot press the “cancel” so the only way to get out of this is to pull the power. Maybe the setup file is corrupted?? I dont know what else to do. Maybe the Brunner folks will chime in next week???

[jake]

Just wanted to let you know and thank you for helping. After 1 hour of spinning i cut the power and restarted the computer. Went to “add and remove programs” and v-joy was there. So back to the profile manager and to the buttons tab, and v-joy was active. So I programmed button 1 to toggle parking brake, and button 7 to toggle pushback and all is good. Thanks so much!!!!!

[webmaximus]

That’s great, happy you got it working!

[Author]

Posts