FORUM › Forums › Products › CLS-E Joystick › Brunner Yoke crash dives when using Autopilot in MSFS
- This topic has 0 replies, 1 voice, and was last updated 3 years, 3 months ago by thedazman.
-
AuthorPosts
-
12/06/2021 at 11:05 #2452thedazmanParticipant
Hi,
I can not use ANY autopilot function in MSFS when Brunner joke and software (CLS2Sim v4.29.3) active. Works fine with other sticks.
When I activate the AP the aircraft rolls and dives sharply.
I have unticked all autopilot stuff in my profile and the same issue persists. Revert to another joystick and turn off Brunner yoke software and MSFS AP works perfectly. I have had this problem since MSFS was released and thought it was a problem with MSFS up until trying a different flight control.
I am using Stefans default Cessna Profile
GER1104 CLSE Yoke Firmware v358.
Just tried resetting a profile to defaults and as soon as I press the AP button it banks HARD away from the path set and inverts and dives straight down
Please help getting very frustrated
-
AuthorPosts
- You must be logged in to reply to this topic.