FORUM › Forums › Products › CLS-E Joystick › CLS Joystick not mounted properly??
- This topic has 1 reply, 1 voice, and was last updated 5 years, 1 month ago by blaser.
-
AuthorPosts
-
03/09/2019 at 18:26 #1406blaserParticipant
Hi There
I have installed the CLS-E joystick so that the arrow is closer to me and cabling interface in the back (away from me and not seen). I have pitch and roll reverse selected in the CLS2sim software and it works properly.
Meanwhile, when I select Yoke is pulled forward by elevator weight option, the stick is pulled instead of being pushed by the elevator weight. The stick comes towards me and in the sim the elevator is in the up position.
The only remedy to this is to turn the stick so that the cables are towards me but I believe this is not how it should be.
I use X-plane 11, CLS2Sim V4.23.3 and firmware v412.
Any help is appreciated
03/09/2019 at 18:49 #1407blaserParticipantI found the solution! A negative sign has to be used in the stick is pulled forward by elevator weight cell. This was very tricky though!
-
AuthorPosts
- You must be logged in to reply to this topic.