CLS2SIM Software "INIT" option

[franciscoblas]

Hi Stefan,

After flying and shutting down sim, I also turn off power to yoke via power strip/cord. I start up the sim and turn on the power strip/cord the yoke goes through init cycle. No problems here, but when I open up the CLS2SIM Software and hit the “init” option, my yoke does not do anything. I hear a slight sound but that’s it, yoke does not go through init cycle. Is this because yoke has already done init process at startup?

If I turn off power via the yoke button and power back on again later, then try to use CLS2sim init, the yoke does not do anything as stated above.

Is this because yoke has already done init process at startup?

fly safe

[franciscoblas]

Hi Stefan

When I download a profile from the cloud the profile does not show up immediately on the list, I have to close CLS2sim then open it again and the list is updated.

fly safe

[sbrunner]

Hi

The yoke needs to init only once after power up.. (moves through the range)
so this is fine

Regards

Stefan Brunner

[franciscoblas]

Okay, thank you Stephan

fly safe

[hellmut1956]

CLS2Sim shows yellow: Connected but not init

[Author]

Posts