FORUM Forums Products CLSE-Yoke How to you disable Button #1 and stop Trim switch from moving yoke?

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
  • #2422

    Hi all,

    Sorry if this sounds confusing, but when using the Brunner Yoke with FS2020, I noticed that the trim switch moves the yoke even when the trim switch is to “Not Bound” under Buttons. I also noticed that pressing the Button #1 on the yoke resets the trim and abruptly moves the yoke, even though Button #1 is not bound.

    How do I resolve this issue, if it is possible?



    Could it be because you have hardware trim enabled?


    I tried with that disabled, unfortunately it did not seem to make a difference.


    Open a ticket we will send you a firmware update

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.


In the BRUNNER forum you will find various discussions on different topics, such as setup, software use or general questions and concerns. 

Discuss with forum mebers, share your knowledge and experience or find answers to frequently asked questions that are answered directly by our Brunner team.

Go to BRUNNER Forum.

BRUNNER Helpdesk​

Do you have questions about a product you have already purchased or are you facing technical issues? 

Check our FAQs for quick help. The most common questions or problems are described there, including instructions.

If you are still stuck, please contact our BRUNNER Helpdesk. Open a ticket here.

BRUNNER Simulation​

BRUNNER is a leading manufacturer of flight simulation devices for the professional as well as the enthusiast sector.

Unlike other manufacturers, Brunner offers a realistic flight experience with the help of Force Feedback Technology and Control Loading System.

Discover the BRUNNER Shop.

BRUNNER Simulation

Industriestrasse 27
8335 Hittnau

+41 (0)44 953 10 10

© 2023 BRUNNER Elektronik AG | Privacy Policy |  Legal notice