FORUM › Forums › Products › CLS-E Joystick › In DirectX mode, joystick shakes when calibrating
- This topic has 0 replies, 1 voice, and was last updated 7 months ago by Mnemonic.
Viewing 1 post (of 1 total)
-
AuthorPosts
-
02/05/2024 at 18:28 #3795MnemonicParticipant
When I switch joystick to DirectX mode, it shakes when turned on during calibration process when touching left side of the base.
Is it normal? I feel that because of it center position of the stick is slightly offset.In the default CLS2Sim mode calibration is smooth and without shaking.
Also I noticed that in DirectX mode when simulating deadstick, there is spring force applied at the edges of envelope of X and Y axis, that pushes stick outward, it might be the reason of shaking too.
Any idea if this can be fixed?
-
AuthorPosts
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.