FORUM › Forums › Software › CLS2SIM Software › using the cls-e joystick as a h pattern shifter
- This topic has 1 reply, 2 voices, and was last updated 2 years, 11 months ago by twitchyrudder.
Viewing 2 posts - 1 through 2 (of 2 total)
-
AuthorPosts
-
03/10/2021 at 17:48 #2566dragn09Participant
hi, did someone at brunner already think about using the joystick as a shifter?
the gears could use a low ffb strength and where there isnt one it could be set to 100% to simulate the “lanes” to the gear activation 🙂27/10/2021 at 12:01 #2583twitchyrudderParticipantI was screwing about with the forces and managed to end up with a profile somewhat like a shifter, however assigning it properly is the next challenge…
-
AuthorPosts
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.