Yoke Violently Shaking while Taxi

[btseven7]

My yoke seems to go crazy while I am taxing on the runway sometimes. A few times it does it for a few seconds then stops and just now after landing at CYYC in the A2A Commanche 250 during the taxi on the runway it started shaking violently. I shut down the aircraft and it was still going quite crazy. I had to disconnect the yoke in CLS2Sim software before it would stop. It seems like the yoke is shaking as hard as it can. Please let me know any thoughts on how I can fix this. This is my first day using the Yoke. I am using the C172 profile from Brunner and I have turned on Motor, Ground & Turbulence vibrations. Stick Shaker is also enabled but I believe that was standard on the profile.

General settings are attached.

Thanks!

Brian
Denver, CO

Attachments:

You must be logged in to view attached files.

[sbrunner]

Hi Brian
Can you disable
1. Ground Vibrations and try..
2. Turbulence

Try default C172
We have not tested A2A Comanche…

Tell me your results

Regards

Stefan Brunner

[sbrunner]

Hi Brian

We send you a mail for an update of CLS-E Yoke to version v349

Regards

Stefan Brunner

[webmaximus]

I just replied to another post on the same topic where the yoke sometimes shakes violently and I experienced the same thing with the PMDG NGX a couple of times. Been a while now since it happened last time though fingers crossed.

If part of the solution is to use the latest firmware I would very much like to have that one too so please let me know how to obtain it.

[Diego Bürgin]

If you open a ticket in the Helpdesk, we will send you the link.

[webmaximus]

Thanks Diego, just created a ticket.

[Author]

Posts