[kevin]

Hi Stefan,

Thanks! I think my issue may be the force profile. I will double check that setting.

Regards,
Kevin

[kevin]

Another Settings
CLS2Sim v4.20.1 [Effects] tab settings
– Yoke is pulled forward by Elevator weight section
– Speed at Yoke starts to be affected = 0
– Speed at which yoke gets pushed to middle = 0

Results – Notice yoke start to move from full forward towards back starting around 80~90 IAS, likely similar to previous setting.

May be Yoke Effects setting is being overwritten by the new flight modeling of XP 11.32?

[kevin]

Performed additional “ground test” …

Settings
CLS2Sim v4.20.1 [Effects] tab settings
– Yoke is pulled forward by Elevator weight section
– Speed at Yoke starts to be affected = 35
– Speed at which yoke gets pushed to middle = 50

Test results (IAS reading from CLS2Sim v4.20.1)
– No Yoke movement at 35 or 50 IAS (full forward)
– Yoke begins to pull back at 90 IAS and continues to pull back as aircraft accelerates
– Reducing speed from 110 IAS, Yoke moves forward as aircraft slows, at around 50 IAS Yoke movement stays around middle
– Speed below IAS 50, yoke move to full forward position

It would appeared that the initial push to middle at IAS 50 function doens’t work ?

Any thoughts on how to correct this issue or if I’m missing something in the setting?

Thanks.

[Author]

Posts