Forum Replies Created
-
Posts
-
It turned out the USB connection inside the unit had come loose. I had to open the USB and re-seat it.
Hi. My settings seem to match yours exactly. I do not have the Force map turned on. I checked the control settings, and here’s the thing. CLSE MKII Rudder shows up, but when you filter to ‘Assigned’, nothing shows. And yet rudder and yoke are both working perfectly. This means the CLS2Sim software is passing these control settings directly to MSFS via the API and it’s not treated as a regular controller that you would assign under MSFS Controls settings.
What does your main CLS2Sim window look like? Do you have pitch roll and yaw green? Connection to MSFS is also green?
Hi. I’m not at home to double check but only usb is from rudder to PC. Rudder to yoke is ethernet. I think only rudder shows, but I think it has 3 axis which is the rudder and the two yoke axis under that one controller. I’ll double check later.
Yes, it was necessary and I was given instructions by support who confirmed it would not invalidate the warranty under the circumstances.
Thank you for all the suggestions. Turns out this was caused by an unseated USB connector (handle to main board) inside the unit.
Tried different USB cable. Same problem. Uninstalled and re-installed latest software. Same problem.
I just noticed that the buttons are not even showing any activity inside the ‘Buttons’ tab in the Brunner software. Maybe I have a faulty unit?
