[maxam]

Have you tried submitting a ticket to Brunner? Click on “HELPDESK” at the top of the page.

[maxam]

@kooela – What issue are you experiencing?

[maxam]

I unchecked Pitch and Roll “Enabled” in the Autopilot tab in the CLS Profile Manager, everything is smooth once again.

Robert

[maxam]

Hi Richard,

Thanks very much for posting your profile, it loads into the CLS Profile Manager so I will give it a try. I’m still using X-Plane quite a bit and of course MSFS but I imagine that I will use MSFS a lot more when the PMDG 737 is released. I do like the FlyByWire A32x, I bought the full A320 setup so I enjoy flying it with the appropriate gear.

Thanks again,
Robert

[maxam]

Hi Richard,

Do you have screenshots of your 737 settings for the CLS-E yoke? I use the CLS-E NG and cannot download your profile and it is not available here at the Brunner cloud. I’d like to get a relatively accurate feel if possible.

Thank you!
Robert

[maxam]

Hello Diego,

I posted twice in the forum and my questions were not answered:

Post 1:

I do not have “Yaw” in the Axis Range Settings as per https://cls2sim.brunner-innovation.swiss/CLSProfileManager.htm#range

I do not have a force feedback rudder, is this why it is not listed?

Regards,
Robert

Post 2:

Hi,

I have set CLSE NG Yoke up in the CLS2Sim UI Version 4.27.6 as per the instructions:

“Do not map any axis in the Simulator over vjoy or game controller, this is done in CLS2Sim (Force map vJoy Axes to Pitch/Roll is not needed)”

The aileron and elevator do not move unless I assign the axis in MSFS. Am I misunderstanding something here?

Regards,
Robert

[maxam]

Hi,

I have set CLSE NG Yoke up in the CLS2Sim UI Version 4.27.6 as per the instructions:

“Do not map any axis in the Simulator over vjoy or game controller, this is done in CLS2Sim (Force map vJoy Axes to Pitch/Roll is not needed)”

The aileron and elevator do not move unless I assign the axis in MSFS. Am I misunderstanding something here?

Regards,
Robert

[maxam]

I do not have “Yaw” in the Axis Range Settings as per https://cls2sim.brunner-innovation.swiss/CLSProfileManager.htm#range

I do not have a force feedback rudder, is this why it is not listed?

Regards,
Robert

[maxam]

Hello Diego,

Thanks for being on top of the issue. I have submitted a ticket to Microsoft myself.

Can’t wait to get the yoke back, it was an amazing experience during testing.

Regards,
Robert

[maxam]

I am sure there is lots that is keeping Stafan busy:

Hi

Just install it… and update the plugins (X-Plane, vjoy)
your settings should not be lost

if you want to make a backup of your old version copy or rename the CLS2Sim folder

Regards

Stefan brunner

Updating CLS2Sim Software

[Author]

Posts