[tzangetsu]

Thanks Stefan, I played around with those settings, the vibration seems so muted compared to the CLS-E pedal vibrations. I had to disconnect the pedals just to feel anything from the yoke. Even at 100% force, it’s barely there. I haven’t experienced the vibration on the CLS-E NG, so I can’t compare. But if I were to put number on the vibration based on feel, I’d say (pedals: 100%, yoke:5-7%). Is that normal?

It would also be nice to have two checkboxes that control which axis have engine vibrations enabled, similar to the stick shaker options.

[tzangetsu]

Yeah, I have a ticket open. I’m based in the US, but I’d definitely prefer to send it back to them to avoid voiding the warranty.

[tzangetsu]

I run into an issue where the buttons don’t work regardless of what I do. I can change the grip type to the CM2 variant, close CLS2SIM then power cycle the joystick as per instructions in the software. But when I re-open CLS2SIM, it’s always recognized as the VPC T-50 grip and not the CM2 version.

I have firmware 394, so I thought it was just an old firmware issue, until I found this post where Stefan mentioned the bit about a “small hardware change”. Is this something that requires the joystick to be sent back to Brunner to get taken care of?

[tzangetsu]

Hi Stefan, Any idea what can be done to support the CM2 grip on my joystick? I ordered shortly before June as you indicated above.

[Author]

Posts