[franciscoblas]

It seems the Microsoft Visual ++ version that comes with the CLS2SIM was not enough to allow the plugin to load. It was solved by installing the latest version.

[franciscoblas]

My yoke came with the adapters. I’m in the US as well

[franciscoblas]

This is the folder I copied

xplane11/resources/plugins/XPlane10Connector <—- this folder

to

xplane12/resources/plugins/XPlane10Connector

fly safe

[franciscoblas]

Hi Blaser,

I will give this a try, thank you for your help.

fly safe

francisco

[franciscoblas]

Regarding the video at 44:50, he presses the trim and the trim reacts quite fast. My trim does not react this quickly. In fact, it is terribly slow. Is it because he is using X-Plane and I am using Prepar3d?

How do I get my trim to react the same way?

fly safe

francisco

[franciscoblas]

Hi Stefan,

Thank you for your help and patience with me via teamviewer.

Francisco

[franciscoblas]

Hi Stefan,

Is it possible to send me the latest firmware so i can reflash the yoke, maybe that will help. Being that we are 12 hours difference it is almost impossible to use teamview. When you asked for teamview ID, I was at work at the time, not in front of my PC. Have you seen the video of the problem? I’ve already updated to latest CLS2Sim version, still same issue. I have put less than 40 hours of use since receiving this yoke and such an issue like this arises. i would like to get back to flying again.

Thank you for any help.

Francisco

[franciscoblas]

Hi again, I believe I have a hardware problem

Francisco

[franciscoblas]

I forgot to add that after powering yoke, when I press “init” on yoke, the yoke slams abruptly to left, then right.

Francisco

[franciscoblas]

Okay, thank you Stephan

fly safe

[franciscoblas]

Yes, it is still an issue. I wrote disregard by accident and can’t delete it.

fly safe

[franciscoblas]

Hi Stefan

When I download a profile from the cloud the profile does not show up immediately on the list, I have to close CLS2sim then open it again and the list is updated.

fly safe

[franciscoblas]

please delete

[franciscoblas]

Hi Stefan

Also I notice an issue when choosing a profile aircraft as default using the (L) beside the name of the aircraft used, most of the time it goes to the default name only and I have to chose the other name again then two aircraft are labled as follows:

default config (L)
c172 (L)

When I choose to delete the (L) from default it does not work and deletes the c172 (L) instead. Perhaps another problem with CLS2sim.

Thank you for your help.

fly safe

[franciscoblas]

Hey Larry,

I take off, reach altitude of 6,000, turn on autopilot. I always turn off autopilot at least 1,000 before landing. Shut down P3d, then CLS2sim.

I remember doing the “overpowering of the yoke” once and everything was back to normal after that but I never did that again when it happened again, I just closed all apps and rebooted my PC.

My sim crashed tonight and the event viewer showed CLS2sim as the cause.

fly safe

[Author]

Posts